Course Resources

See below for a full listing of downloadable course content.

Lab Lecture Topics Lecture Resources Lab Topics Lab Resources Homework
1
  • Course overview
  • AutoCAD Chapter 1: AutoCAD Fundamentals
  • AutoCAD Chapter 1: AutoCAD Fundamentals – Guide Plate
  • Page 1-19 to 1-26
  • 1) Spacer Design (page 1-27)
  • 2) Ex 4 Channel Plate (page 1-39)
2
  • AutoCAD Chapter 2: Basic Object Construction Tools
  • Rocker Arm Design
  • AutoCAD Chapter 2: Basic Object Construction Tools – Ex. 1 & 2
  • 1) Ex. 1 Adjustable Support
  • 2) Ex 2 V-Slide Plate
  • Page 2-30
  • Ex 4 Sensor Mount (Page 2-31)
3
  • AutoCAD Chapter 3: Geometric Construction and Editing Tools
  • Ex. 2 Interlacement Design
  • Page 3-41
  • AutoCAD Chapter 3: Gasket Design
  • Page 3-22 to 3-39
  • 1) Ex 3 Positioning Spacer
  • 2) Ex 4 Indexing Base
4
  • AutoCAD Chapter 4: Object Properties and Organization
  • Floorplan Design
  • Page 4-3 to 4-28
  • Work on your midterm project
  • Midterm project (due Friday by 8 pm to Bblearn)
5
  • Creo Chapter 2 & 3: Introduction & Sketcher
  • Sketcher Practice
  • Creo Chapter 3: Sketcher Exercise
  • Sketcher Exercise Figure 3-57, 3-63, and 3-69
  • Problem 3.5 Rocker (Page 71)
6
  • Creo Chapters 4: Extrusions
  • Pipe Support Jig
  • Creo Chapter 4: Extrusions Exercise
  • Stocktail Clamp 197
  • Page 93
  • 1) 4.2 Operating Arm (Pg 105)
  • 2) 4.6 Cross-feed Stop (Page 107)
7
  • Creo Chapter 5: Revolves
  • Stepshaft
  • Creo Chapter 5: Revolves Exercise
  • Cone Clutch
  • Page 137
  • 2) 5.5 Idler Pulley (Page 151)
8
  • Creo Chapter 6: Patterns
  • 1) Erector Set Plate
  • 2) Saw Blade
  • Creo Chapter 6: Patterns Exercise
  • Dual-Tooth Sprocket
  • 1) Final Project Proposal
  • 2) 6.4 Bearing Cup (Page 193)
  • 3) 6.6 Shelf Support (Page 194)
9
  • Creo Chapter 9: Assemblies
  • Example Assembly
  • 1) Project Proposal Review
  • 2) Creo Chapter 9: Assembly Exercises
  • Take-Up Piece Assembly, Figure 9-92 (page 307 - 322)
  • Complete Take-up Assembly, Figure 9-117 (Page 322 - 332)
10
  • Creo Chapters 7: Creating an A-size Format Sheet (Pages 197 to 218, 222 to 238)
  • Creo Chapters 7 & 8: Engineering Drawings (Pages 252 to 259)
  • Creo Chapter 10: Assembly Drawings
  • Work on Final project
  • Final project due by Wednesday of Finals Week at 5pm to BbLearn
11
  • Final Week
  • Final project due by Wednesday of Finals Week at 5pm to BbLearn